HP Surestore Tape Library Model 20/700 HP Surestore Tape Library Model 20/700 - Page 82

Chapter 3 Setting the Library Name The system administrator might assign the library a name. The name is mapped to the IP address but does not affect operation. To set the library name: 1. At the Network Config menu, press an arrow button until the cursor underscores LIBRARY NAME. 2. Press the [SELECT] button. An editing screen appears. 3. On the editing screen: a. Use the up and down arrow buttons to select a value for each character (field) in the name. b. Use the [SELECT] button to move right to the next field. c. Use the [MENU] button to move left to the previous field. Note Do not enter a library name longer than 30 characters. 4. When the screen displays your desired setting, press the [SELECT] button twice to save the changes. You may press the [MENU] button from the leftmost field to abort. 5. If you have already changed the library's SCSI ID and are planning to exit the main Configuration Menu at this time, you must press the [RESET] button. If you wish to set other configuration values, continue with the next section. If you have not changed the library's SCSI ID and are not setting other configuration values, press the [MENU] button until you exit all menus. Chapter 3 Entering Configuration Data 81