HP Surestore Tape Library Model 20/700 HP Surestore Tape Library Model 20/700 - Page 84
Setting the Network Gateway Address, Setting the Subnet Mask, Address
View all HP Surestore Tape Library Model 20/700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
Chapter 3 Setting the Network Gateway Address A network gateway in a large network allows devices on one subnet to interface with devices on another subnet (see Setting the Subnet Mask Address on page 84). This four-byte address must be specified by the system administrator. Note Entering this address is optional. It sets up the gateway connection between subnets, but it is applicable only when such a connection exists and is necessary for library operation. Consult with your systems administrator for additional information. To set the network gateway address: 1. At the Network Config Menu, press an arrow button until the cursor underscores NETWORK GATEWAY. 2. Press the [SELECT] button. An editing screen appears. 3. On the editing screen: a. Press the up and down arrow buttons to select a value for each threedigit field in the address. b. Press the [SELECT] button to move right to the next field. c. Press the [MENU] button to move left to the previous field. 4. Press the [SELECT] button from the right-most field to when the screen displays your desired setting to save the changes. (You may press the [MENU] button from the left-most field to abort.) 5. If you have already changed the library's SCSI ID and are planning to exit the main Configuration Menu at this time, you must press the [RESET] button. If you wish to set other configuration values, continue with the next section. If you have not changed the library's SCSI ID and are not setting other configuration values, press the [MENU] button until you exit all menus. Chapter 3 Entering Configuration Data 83