IBM 4851 514 Service Guide - Page 30
Powering, states, Using, setup, utility
![]() |
View all IBM 4851 514 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Installing the IBM SurePOS 500 Model 514 Updated October, 2008 Powering on and the LED states 1. Plug the power cord into the SurePOS 500 Model 514 and then plug into an electrical outlet. Figure 12. Location of power switch and screen brightness adjusting buttons 2. Power on the system using the power switch ( C in Figure 12). The power light-emitting diode (LED) appears green. 3. Select the plus + ( A ) or minus - ( B ) buttons to adjust the screen brightness. 4. Verify that the system is operating correctly by checking the indicator lights (LEDs) on the front of the touch screen. Status/power indicator HDD indicator On: Logic working correctly. SourceACpower present and within tolerance. Off: The unit is powered off. Blinking: System is executing POST code On HDD is reading or writing Off: No HDD activity Blinking: HDD is reading or writing Using the setup utility Follow these steps to start the Setup Utility: v Switch the power ON. v Press Del during POST when prompted, or tap the touch screen two times. Use the keys listed in the legend bar at the bottom of the screen to make your selections or exit from the current menu. The help window on the right side of each menu displays the online help information for the currently selected item. You can use either a keyboard or the touch screen to make selections. The Setup Utility allows you to observe information or make changes in following areas: v Standard CMOS Features v Advanced BIOS Features 14 SurePOS 500 Model 514
![](/manual_guide/products/ibm-4851-514-service-guide-fdcec3e/30.png)