IBM 4851 514 Service Guide - Page 81
Removing
View all IBM 4851 514 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
Updated October, 2008 Removing and replacing FRUs Figure 50. Tailgate remove and replace. This figure shows the screws removed for illustration purposes only. 3. Remove the rear inner metal cover. See "Rear metal panel cover - removing and replacing" on page 62. 4. Remove the power supply. See "Power supply - removing and replacing" on page 68. 5. See Figure 50. Loosen the five screws, but do not remove them. 6. Pull the connector panel out and disconnect the fan cable from the system board. Reverse the steps to reassemble. Make sure the two connectors on the back of the tailgate line up with the connectors on the system board. Removing the fan To remove and replace the fan: 1. Remove the rear cover as described at "Rear cover - removing and replacing" on page 61. 2. Remove the rear inner metal cover. See "Rear metal panel cover - removing and replacing" on page 62. 3. Disconnect the fan cable from the system board. 4. Loosen the two screws holding the fan and remove. 5. To replace, align the fan with the two screw holes, insert and tighten screws. 6. Connect the fan cable to the system board. Chapter 5. Removing and replacing FRUs 65