IBM 4851 514 Service Guide - Page 72
Display, tablet, cable, removing, replacing
![]() |
View all IBM 4851 514 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
Removing and replacing FRUs Updated October, 2008 Figure 41. Removing the tablet back cover 2. With the tablet face down on a sturdy surface, loosen the three screws along the bottom edge of the tablet. See B in Figure 41. 3. If installed, remove the antenna cover. 4. Using both hands, lift the base rear upward and tilt it at an angle to remove. Display tablet cable - removing and replacing 1. Remove the tablet. See "Display tablet - removing and replacing" on page 55. 2. Disconnect the cable from the bottom rear of the tablet. 3. Remove the HDD front cover as described at "HDD cover - removing and replacing" on page 73. 4. Disconnect the cable clamps holding the tablet cable. 5. Remove the rear cover as described at "Rear cover - removing and replacing" on page 61. 6. Remove the power supply as described at "Power supply - removing and replacing" on page 68. 7. Disconnect the connector from the system board. 8. Remove the base plate. See "Base plate - removal and replacement" on page 77. 9. Pull the cable free from the plastic guide in the frame. 56 SurePOS 500 Model 514
![](/manual_guide/products/ibm-4851-514-service-guide-fdcec3e/72.png)