IBM 4851 514 Service Guide - Page 75
assembly, removal, replacement
View all IBM 4851 514 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
Updated October, 2008 Removing and replacing FRUs Figure 44. Removing the tablet touch card 4. See Figure 44. Lift off the backlight card EMC shield and set aside. 5. Disconnect the tablet touch card connector. 6. Remove the tablet EMC shield ( C in Figure 43 on page 58) by removing the remaining screw. 7. Slide the tablet EMC shield downward and lift to remove. 8. Disconnect the remaining cables attached to the card. 9. Remove the four captured screws and lift out the tablet touch card. 10. To replace, reverse these procedures. LCD assembly - removal and replacement 1. Remove the tablet as described in "Display tablet - removing and replacing" on page 55. 2. Remove the tablet rear as described in "Display tablet back cover" on page 55. 3. Unplug the connector from the control card. Chapter 5. Removing and replacing FRUs 59