IBM 4851 514 Service Guide - Page 97
Common, cash-drawer, removing, replacing
View all IBM 4851 514 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
Updated October, 2008 Removing and replacing FRUs Slide Assembly Screws Latch Assembly Latches Figure 67. Removing cash-drawer slide assembly To replace the cash-drawer slide assembly: 1. Place the slide assembly into the base so that the screw holes are aligned. 2. Insert the screws that secure the slides into the base. 3. Reinstall the latch and sensor assembly. 4. Reinstall the top cover if it was removed. 5. Reinstall the drawer. Common cash-drawer FRUs - removing and replacing This section describes how to remove and replace compact cash-drawer-related FRUs that are common to both the full-size and compact cash drawers. Removing and replacing the top cover To remove the top cover of a cash drawer: 1. Disconnect the cash drawer cable from the rear of the cash drawer. (Other cables could be routed through the rear of the top cover.) Remove the rear panel by releasing it at the pivots. Separate the top cover and base without disturbing these cables. Disconnect cables from the terminal unit when necessary. 2. Open the rear panel by pushing the buttons at the upper rear corners of the cover. 3. Set the devices mounted on the top cover to the side. 4. Remove the drawer (see "Removing and replacing a full-size drawer" on page 79. 5. To separate the top cover from the base, reach in from the front and push the cover latches outward while pushing them to the rear. The cover slides off toward the rear (see Figure 68 on page 82). Chapter 5. Removing and replacing FRUs 81