IBM 4851 514 Service Guide - Page 83
Update, system, software, System-board, jumper, location, settings
View all IBM 4851 514 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
Updated October, 2008 Removing and replacing FRUs 7. Remove the five screws, as shown in Figure 51 on page 66. 8. To install the new system board, reverse these steps. The new system board comes with all required jumpers and with a new battery. Update system software 1. Ensure system BIOS is equal to or greater than that from the old system board. 2. Reprogram the Vital Product Data (VPD). a. Boot the service diskette. b. Choose POS System Test. c. Choose Utilities. d. Choose Vital Product Data Utility. e. Choose Update VPD. f. Choose the model and press Enter. g. Choose Update VPD again. h. Enter the machine serial number and press Enter. i. Exit. System-board jumper location and settings Figure 52 shows the system-board jumper location ( A ). Figure 52. System board jumper location Table 10 on page 68 lists the system board jumper settings. All jumper pins have the pin number printed on the system board for easy identification. Chapter 5. Removing and replacing FRUs 67