IBM 4851 514 Service Guide - Page 50
Notes, full-size, keyboard-integration, countertop
![]() |
View all IBM 4851 514 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Mounting the SurePOS 500 Model 514 Updated October, 2008 a. Remove the rear cover. Notes: 1) If you are routing cables underneath the counter, route them through the cable-access hole in the counter. 2) If you are routing cables on top of the counter, route them out the back of the system. Lay them flat along the countertop. 2. For a free-standing unit, ensure that the four rubber feet A are installed on the bottom of the countertop keyboard integration tray (as shown in Figure 26 on page 35). 3. To secure the full-size keyboard-integration tray to a countertop, perform the following steps: a. Remove the fence E from the countertop keyboard-integration tray by removing the screws as shown in Figure 26 on page 35. b. Drill the four mounting holes and cut a hole in the countertop for cables if needed. Use the openings in the integration tray as a pattern for drilling mounting holes and a cable opening in the counter. c. Remove the rubber feet A located on the bottom of the integration tray. See Figure 26 on page 35 for location of feet. d. Attach the keyboard-integration tray to the countertop using four mounting screws, one at each corner of tray. The four mounting screws are not provided with the kit. Use 60-mm (0.25-in.) pan-head screws. e. Reattach the fence E to the tray with the six small screws. 34 SurePOS 500 Model 514
![](/manual_guide/products/ibm-4851-514-service-guide-fdcec3e/50.png)