IBM 4851 514 Service Guide - Page 62
non-keyboard
View all IBM 4851 514 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
Installing additional peripheral devices C A B Updated October, 2008 Figure 37. Attaching and routing the cables to the printer. 6. Connect any other signal cables for I/O devices to the correct ports. 7. If you are installing a freestanding printer, route the cables to the rear connector panel on the SurePOS 500 Series system unit. Pass the cables under the cable-tie bar, and plug it into one of the three standard serial ports, as shown in "Rear view and connectors" on page 5. 8. Go to the appropriate procedure for non-keyboard integration tray or keyboard integration tray mounting of the 4610 TF6 or TF7 printer: v If you are installing a 4610 TF6 or TF7 printer on a non-keyboard integration tray, continue with Step 9. v If installing a 4610 TF6 or TF7 printer on a keyboard integration tray, continue with Step 12 on page 37. 9. To install a 4610 TF6 or TF7 printer on a non-keyboard integration tray, perform the following steps: a. Attach the printer mounting plate to the bottom of the printer. The mounting plate slides into the two bottom slots of the printer. Figure 38. Attaching the 4610 TF6 or TF7 printer mounting plate for a non-keyboard integration tray b. The procedure for mounting the printer to a non-keyboard integration tray is the same for countertop or cash drawer. With the mounting plate attached to the printer, slide the front of the printer mounting plate into the slots located 46 SurePOS 500 Model 514