IBM 4851 514 Service Guide - Page 61
assignment.
View all IBM 4851 514 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Updated October, 2008 Installing additional peripheral devices v For the keyboard integration tray, the 4610 TF6 or TF7 is set into a plastic printer base and then set on the keyboard integration tray. Figure 36 shows the 4610 TF6 or TF7 printer connectors. A B C E D Figure 36. 4610 TF6 or TF7 printer connector locations A Power supply port (RS-232 only) D Cash drawer connector B RS-232 port or Powered USB port E RS-232 mode switch C (Not used on the SurePOS 500 Series) To install the 4610 TF6 or TF7 printer, perform the following steps: 1. Switch OFF the power at the system unit. 2. Remove the SurePOS 500 Model 514 rear cover (see "Rear cover - removing and replacing" on page 61). 3. Remove the SurePOS 500 Model 514 power supply (see "Power supply - removing and replacing" on page 68) to get access to the SurePOS 500 Model 514 rear connector panel. See "Rear view and connectors" on page 5 for rear connector port assignment. 4. Check the printer RS-232 mode-switch setting for the printer. It is near the rear cable connections. See E in Figure 36 for switch location. For switch settings, see the IBM 4610 SureMark Point-of-Sale Printers User's Guide. 5. Connect and route the RS-232 communication cable or Powered USB cable A and the power supply cable B as shown in Figure 37 on page 46. Chapter 3. Mounting the SurePOS 500 Model 514 45