IBM 4851 514 Service Guide - Page 71
Display, tablet, components, removing, replacing
![]() |
View all IBM 4851 514 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Updated October, 2008 Removing and replacing FRUs Display tablet components This section describes how to remove the display tablet and its FRU components. Note: Components of the tablet are available for field replacement, but the entire tablet is not a FRU. Display tablet - removing and replacing Refer to Figure 40. 1. Tilt the tablet back and loosen the two thumbscrews ( A in Figure 40 and Figure 41 on page 56) under the tablet. 2. Disconnect the cable (by squeezing on either side) from the bottom rear. 3. Lift the tablet off the base. Figure 40. Display tablet, remove and replace To replace, reverse this procedure. Display tablet back cover 1. Remove the tablet from the base as described above in "Display tablet - removing and replacing." Chapter 5. Removing and replacing FRUs 55
![](/manual_guide/products/ibm-4851-514-service-guide-fdcec3e/71.png)