IBM 4851 514 Service Guide - Page 43
thumbscrews. - 514 details
![]() |
View all IBM 4851 514 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Updated October, 2008 Mounting the SurePOS 500 Model 514 6. Attach the SurePOS 500 Model 514 and its mounting plate C to the right side of the integration tray I as shown in Figure 19 on page 26. Slide the front of the mounting plate under the appropriate pair of tabs on the tray and secure the rear of the mounting plate to the tray with two thumbscrews. 7. Install the IBM 4610 SureMark Printer on the integration tray. Go to "Installing IBM 4610 SureMark Models TF6 or TF7 printers" on page 44 for detailed instructions on mounting plate installation and printer cable routing. a. Attach the printer to its mounting plate as shown in Figure 38 on page 46. b. Install the printer and the printer cables and route the cables as shown in Figure 37 on page 46. 8. Connect the peripheral device cables to the appropriate ports on the rear connector panel. Make the connections on the bottom row of the connector panel first and work upward. Ensure that the cables are routed to the right of the power cord. Note: For a diagram of the port layout, see "Routing and connecting cables to the rear connector panel" on page 12. 9. Use tie-wraps to secure cables to the cable-tie bar, if desired. 10. Replace the rear cover. 11. Plug the AC power cord into an AC outlet. 12. Replace the SurePOS 500 Model 514 rear cover. 13. Install the filler panels after you route all the cables to your system. a. Install the outer ends of the filler panels B into the integration tray. Notice that the printer filler panel, shown on the right, is narrower than the system filler panel. Also, the system filler panel has a bottom slot that allows you to route the cables out the back. b. Use the narrow filler panel A to lock the filler panels together between the system and the printer. A B Figure 20. Connecting filler panels Note: Depending on your desired configuration, you could have unused filler panels. 14. Plug the system and printer AC power cords into an AC outlet. 15. After your installation is complete, press the printer power switch under the printer cover to power On the printer. 16. Switch ON the power to the SurePOS 500 Model 514. Verify that the system is operating correctly by checking the indicator lights (LEDs) on the front of the touch screen. See "Powering on and the LED states" on page 14. Chapter 3. Mounting the SurePOS 500 Model 514 27
![](/manual_guide/products/ibm-4851-514-service-guide-fdcec3e/43.png)