IBM 4851 514 Service Guide - Page 56
connecting
![]() |
View all IBM 4851 514 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Mounting the SurePOS 500 Model 514 Updated October, 2008 Figure 32. Installing the distributed customer display onto the integration tray a. Route the display cable F through hole D , as shown in Figure 32. You might need to place the display on its side to connect the display cable to the system unit rear connector panel. b. Route the display cable to the rear connector panel, passing it under the cable-tie bar, and plug it into the 15-pin serial connector, as shown in "Rear view and connectors" on page 5. c. Attach the distributed customer display A to the cash drawer at location B with two thumbscrews C . 16. Plug the AC power cord to the power supply. 17. Connect the peripheral cables to the appropriate ports on the SurePOS 500 Model 514 rear connector panel. Make the connections on the bottom row of the panel first and work upward. See "Routing and connecting cables to the rear connector panel" on page 12. Notes: a. If you are routing the cables under the counter, route all cables (including the AC power cord) through the cable-access hole. b. If you are routing the cables on top of the counter, route all cables out the rear of the system. Lay the cables flat along the countertop. 18. Use tie-wraps to secure cables to the integration tray. 19. Replace the rear cover and install the rear filler panel. 20. Attach the cash-drawer rear cover by aligning the tabs with the buttons, and push in on the cover. 21. Plug the system and printer AC power cords into an AC outlet. 22. After your installation is complete, press the printer power switch under the printer cover to power on the printer. 40 SurePOS 500 Model 514
![](/manual_guide/products/ibm-4851-514-service-guide-fdcec3e/56.png)