IBM 4851 514 Service Guide - Page 63
tightening
![]() |
View all IBM 4851 514 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
Updated October, 2008 Installing additional peripheral devices toward the front of the integration tray. Secure the printer by tightening the two thumbscrews on the mounting plate to the tray. c. Route the RS-232 cable A to the rear connector panel of the system unit as shown in Figure 39. Plug it into one of the three standard serial ports on the system unit. d. Route the printer power cord B toward the system and out through the hole in the integration tray, as shown in Figure 39. Note: When routing the printer and power cables, make sure that the cables are routed inside the mounting plate screws to enable correct installation of the filler panels. A B Figure 39. 4610 TF6 or TF7 cable routing Chapter 3. Mounting the SurePOS 500 Model 514 47
![](/manual_guide/products/ibm-4851-514-service-guide-fdcec3e/63.png)