Icom IC-80AD Instruction Manual - Page 114
Memory scan
View all Icom IC-80AD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 114 highlights
10 SCAN OPERATION N Memory scan IMPORTANT!: To perform memory scan, 2 or more memory channels MUST be programmed, otherwise the scan will not start. q Push [M/CALL] several times to select memory mode. w Set the squelch level. e Push and hold [SCAN](V/MHz) for 1 sec. to enter the scan- ning type selection. r Rotate [DIAL] to select the desired scanning type. • "ALL" for all memory scan; "BAND" for band memory scan, "MODE" for mode scan, "DUP" (appears only when duplex operation is set) for duplex scan. [DIAL] Push and hold for 1 sec. All memory scan Rotate Mode scan Selected mode is displayed. Band memory scan Duplex scan t Push [V/MHz] to start the scan. • Scan pauses when a signal is received. • Rotate [DIAL] to change the scanning direction. This also causes the transceiver to resume scanning. • Push [V/MHz] to stop the scan. During memory scan During mode scan Band memory scan function: Repeatedly scans all memory channels programmed with any frequencies of the band programmed in the memory channel selected for scanning. Mode scan function: Repeatedly scans all memory channels in which the same operating mode as the selected memory channel has been programmed. Duplex scan function: Repeatedly scans two frequencies (transmission/reception) during duplex scan operation. 106