Icom IC-80AD Instruction Manual - Page 115

SCAN OPERATION 10 N Memory bank scan IMPORTANT!: To perform memory bank scan, 2 or more bank channels MUST be programmed, otherwise the scan will not start. q Select memory bank mode. ± Select memory mode with [M/CALL]. ± Enter the bank selection state with [BAND]. ± Set the desired bank (A to Z) with [DIAL], then push [BAND]. w Set the squelch level. e Push and hold [SCAN](V/MHz) for 1 sec. to enter the scan- ning type selection. [DIAL] Push and hold for 1 sec. All bank scan Rotate Bank scan Selectable from "A" to "Z" if programmed. Bank link scan Duplex scan r Rotate [DIAL] to select the desired scanning type. • "ALL" for all bank scan; "B-LINK" for bank link scan or "BANK-x" for bank scan (x= A to Z; programmed bank groups are only displayed.), "DUP" (appears only when duplex operation is set) for duplex scan. t Push [V/MHz] to start the scan. • Scan pauses when a signal is received. • Rotate [DIAL] to change the scanning direction. This also causes the transceiver to resume scanning. • Push [V/MHz] to stop the scan. • Push [BAND] to change the bank during bank scan. During all bank/bank link scan During bank scan The bank-link setting can be changed in SCAN set mode. See page 122 for details. Duplex scan function: Repeatedly scans two frequencies (transmission/reception) during duplex scan operation. Memory bank scan skips any memory channels in the selected bank that are set to "SKIP" or "PSKIP." Memory bank scan stops at the first channel when all channels in a bank are set to "SKIP" or "PSKIP." 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 107