Icom IC-80AD Instruction Manual - Page 53
Changing a repeater list
View all Icom IC-80AD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
DV MODE PROGRAMMING 6 Gateway repeater call sign programming (GW CALL) q Push [ ](5) to enter the gateway repeater call sign pro- gramming. • Gateway repeater call sign programming screen is displayed. • Programmed repeater call sign is displayed, then the 1st char- acter blinks. • The 8th digit is automatically added or replaced to "G." w Push [ ](2) or [ ](8) to select the desired character, number, symbol ('/' only) or space. • The selected character blinks. • Push [ ](6) to move the cursor right; push [ ](4) to move the cursor left. • Push [CLR](1) to erase the selected character, or push and hold [CLR](1) for 1 sec. to erase all characters following the cursor. e Repeat step w until the desired repeater call sign is programmed. • Up to an 8 digit call sign can be set, but 8th digit must be set to "G." r Push [ ](5) to program the gateway repeater call sign and exit the state. N Changing a repeater list 1 You can edit the contents of a repeater list to correct errors or 2 added information. 3 q Enter "EDIT-L" in RPT-L menu. 4 MENU ¶ RPT-L ¶ EDIT-L 5 (Push [MENU ]), (Push [ ](2)/[ ](8), then push [ ](5).) 6 • Programmed repeater name appears. SKIP indicator 7 8 9 10 11 SKIP indicator shows the selected repeater can not be used as an access repeater (RPT1) in DR mode as follow reasons. 12 • "R1 USE" is set to "NO" • Either "FREQ" (frequency) or "DUP" (duplex direction) 13 has not been programmed 14 Push and hold for 1 sec. to select SKIP indicator ON or 15 OFF when both of "FREQ" and "DUP" have been programmed. 16 w Push and hold [BAND] for 1 sec. to enter group selection, rotate [DIAL] to select the desired group (0-9), then push 17 [BAND]. e Push [ ](2) or [ ](8) to select the desired repeater list to 18 be changed. 19 45