Icom IC-80AD Instruction Manual - Page 44
Call sign programming
![]() |
View all Icom IC-80AD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
6 DV MODE PROGRAMMING N Call sign programming Four types of current call sign memory are available; "MY" (my call sign=your own call sign) "UR" (your call sign=other station call sign) "RPT1" (access repeater call sign) and "RPT2" (link repeater call sign). Each call sign can be programmed with up to 8 characters. In addition, "MY" can store up to 6 call signs, and "UR" can store up to 60 call signs in the call sign memory. Up to 300 repeater call signs can be stored in the repeater list. D Your own call sign programming Your own call sign must be programmed for both digital voice and low-speed data communications (including GPS transmission). q Enter "MY" in call sign screen. MENU ¶ CALL-S ¶ MY (Push [MENU ]), (push [ ](2)/[ ](8), then push [ ](5).) • MY call sign screen is displayed. w Push [ ](2) or [ ](8) to select the desired call sign memory, "MY1" to "MY6." 36 e Push [ ](6) to enter call sign programming mode. • The 1st digit blinks. r Push [ ](2) or [ ](8) to select the desired character or code. • Push [ ](6) to move the cursor right; push [ ](4) to move the cursor left. t Repeat the step r to enter your own call sign. • Up to an 8 digit of call sign can be set. • If an unwanted character is entered, push [ ](6) or [ ](4) to select the character, then push [CLR](1) to erase the selected character, or push and hold [CLR](1) for 1 sec. to erase all characters following the cursor. • To program a note (up to 4 characters, for operating radio type, area, etc.), go to step y, otherwise go to step i. y Push [ ](6) several times to set the cursor beside "/" indication.
![](/manual_guide/products/icom-ic80ad-instruction-manual-e055bf3/44.png)