Lenovo ThinkServer RD210 Hardware Maintenance Manual - Page 104
until it is seated firmly into the connector on the system board.
![]() |
View all Lenovo ThinkServer RD210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 104 highlights
1 SAS/SATA RAID riser-card 2 ServeRAID-MR10i adapter 7. Tilt the SAS/SATA RAID riser-card assembly slightly and insert the end of the adapter in the slot on the retention bracket as shown in the following illustration. Make sure that the SAS/SATA RAID riser-card assembly keys align correctly with the connector on the system board and press down on the assembly until it is seated firmly into the connector on the system board. 1 SAS/SATA RAID front retention bracket 2 SAS/SATA RAID riser card 3 ServeRAID-MR10i adapter 4 Plastic tab 5 Alignment post 8. Route the signal cables from the drive backplane over the blue adapter retention bracket as shown in the following illustration. 00 0 00 0 00 00 1 Connector for drive bays 0-3 signal cable 2 Connector for drive bays 4-5 signal cable 3 SAS/SATA RAID riser card 4 ServeRAID-MR10i controller 96 ThinkServer RD210 Hardware Maintenance Manual
![](/manual_guide/products/lenovo-rd210-hardware-maintenance-manual-0f207c1/104.png)