Lenovo ThinkServer RD210 Hardware Maintenance Manual - Page 20
Gb Ethernet Daughter Card is, Supports 1 GB, 2 GB, and 8
View all Lenovo ThinkServer RD210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Table 1. Features and specifications Microprocessor: • Supports up to two ®Intel Xeon™ microprocessors, dual-core (two cores per microprocessor with 4 MB shared among cores) or quad-core (four cores per microprocessor with 8 MB shared among cores) • Level-2 cache • QuickPath Interconnect (QPI) links speed up to 6.4 GT per second Notes: • Use the Setup Utility program to determine the type and speed of the microprocessors. • For a list of supported microprocessors, go to www.lenovo.com/thinkserver and click on the Options & Software tab. Memory: • Minimum: 1 GB • Maximum: 128 GB • Type: PC3-10600R-999 (single-rank or double-rank) or PC3-8500R-777 (quad-rank), 800, 1067, and 1333 MHz, ECC, DDR3 registered SDRAM DIMMs only • Slots: 16 dual inline • Supports 1 GB, 2 GB, 4 GB, and 8 GB (when available) DIMMs Size: • Height: 43 mm (1.69 inches, 1 U) • Depth: 711 mm (28 inches) • Width: 440 mm (17.3 inches) • Maximum weight: 15.4 kg (34 lb) when fully configured Integrated functions: • Integrated Management Module (IMM), which provides service processor control and monitoring functions, video controller, and (when IMM Premium is installed) remote keyboard, video, mouse, and remote hard disk drive capabilities • Broadcom BCM5709 Gb Ethernet controller with TCP/IP Offload Engine (TOE) • Five Universal Serial Bus (USB) 2.0 ports • Four Ethernet ports (two on system board and two additional ports when the optional Dual-Port 1 Gb Ethernet Daughter Card is installed) • One System Management RJ-45 on the rear to connect to a systems management network. This system management connector is dedicated to the IMM functions. This connector is active with or without IMM Premium. • One serial port SATA optical drives (depending on your model): • CD-RW/DVD-ROM combo (on standard models) • DVD-ROM (optional) • Multi-burner (Rambo) (optional) RAID controllers: • A ServeRAID-BR10i SAS/SATA Controller that provides RAID levels 0, 1, and 1E (comes standard on some hot-swap SAS and hot-swap SATA models). Hard disk drive expansion bays (depending on the model): • An optional ServeRAID-MR10i SAS/SATA Controller that provides RAID levels 0, 1, 1E, 5, • Six 2.5-inch hot-swap SAS or 6, and 10 can also be ordered. hot-swap SATA hard disk drive bays Acoustical noise emissions: • Sound power, idling: 6.1 bels PCI expansion slots: maximum • Sound power, operating: 6.1 bels Supports two PCI riser slots: maximum • Slot 1 supports low-profile cards (PCI Express Gen2 x16 ) • Slot 2 supports half-length, full-height cards (PCI Express Gen2 x16) Environment: • Air temperature: - Server on: 10° to 35°C (50.0° to 95.0°F); altitude: 0 to 3050 m (0 to 10006 ft) Power supply: - Server off: 5° to 45°C (41° 1•2 to 113°F); maximum altitude: OnTheinpkoSwerevrersuRpDp2l1y0sHtaanrddwaardre Maintenance Ma3n0u5a0l m (10006 ft) • Maximum of two 675-watt ac (110 or 220 V ac auto-sensing) • Humidity: - Server on: 20% to 80% Heat output: Approximate heat output in British thermal units (Btu) per hour: • Minimum configuration: 662 Btu per hour (194 watts) • Maximum configuration: 2302 Btu per hour (675 watts) Electrical input: • Sine-wave input (47-63 Hz) required • Input voltage low range: - Minimum: 100 V ac - Maximum: 127 V ac • Input voltage high range: - Minimum: 200 V ac - Maximum: 240 V ac • Input kilovolt-amperes (kVA), approximately: - Minimum: 0.194 kVA - Maximum: 0.700 kVA Video controller (integrated into IMM): • Matrox G200 (two analog ports - one front and one rear that can be connected at the same time) Note: The maximum video resolution is 1280 x 1024 at 75 Hz. - SVGA compatible video controller - DDR2 250 MHz SDRAM video memory controller - Avocent Digital Video Compression - Video memory is not expandable Notes: 1. Power consumption and heat output vary depending on the number and type of optional features installed and the power-management optional features in use. 2. These levels were measured in controlled acoustical environments according to the procedures specified by the American National Standards Institute (ANSI) S12.10 and ISO 7779 and are reported in accordance with ISO 9296. Actual sound-pressure levels in a given location might exceed the average values stated because of room reflections and other nearby noise sources. The declared sound-power levels indicate an upper limit, below which a large number of computers will operate.