Lexmark X500n Service Manual - Page 154
Rear cover assembly removal, Fuser assembly removal
View all Lexmark X500n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 154 highlights
7100-XXX Rear cover assembly removal 1. Remove the fuser assembly. See "Fuser assembly removal" on page 4-6. 2. Remove the transfer belt unit. See "Transfer belt unit removal" on page 4-5. 3. Remove the right cover. See "Right cover removal" on page 4-13. 4. Disconnect the rear cover assembly connector (A). 5. Remove the support pin (B), disconnecting the support cable from the MFP. 6. Remove two screws (C) from the rear cover assembly. A C B 7. Slide the right side of the rear cover assembly away from the MFP until the hinge clears the slot. 1 2 8. Slide the rear cover assembly toward the right side until the captured end of the rear cover assembly clears the mounting bracket. 9. Remove the rear cover assembly by pulling it away from the MFP. 4-14 Service Manual