Netgear GS728TXS GS728TXS/GS752TXS Software Administration Manual - Page 156
IP Configuration, IP Statistics, To enable routing on the switch, Routing, Enable, Apply
View all Netgear GS728TXS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 156 highlights
GS752TXS and GS728TXS Smart Switches IP Configuration Use the IP Configuration screen to configure routing parameters for the switch. To enable routing on the switch: 1. Select Routing IP > IP Configuration. 2. Next to Routing Mode, select Enable. You must enable routing for the switch before you can route through any of the interfaces. Routing is also enabled or disabled per VLAN interface. The default value is Disable. The following table describes the IP configuration information displayed on the screen. Field Default Time to Live Maximum Next Hops 3. Click Apply. Description The default value inserted into the Time-To-Live field of the IP header of datagrams originated by the switch, if a TTL value is not supplied by the transport layer protocol. The default value is 64. The maximum number of hops supported by the switch. This is a compile-time constant. The default value is 1. IP Statistics The statistics reported on the IP Statistics screen are as specified in RFC 1213. To display the IP statistics screen: Select Routing IP >Statistics. The IP Statistics screen displays. 156