Netgear GS728TXS GS728TXS/GS752TXS Software Administration Manual - Page 209

GS752TXS and GS728TXS Smart Switches 2. Specify the Port Based Authentication State mode on the switch. The default setting is Disable. • Enable. Port-based authentication is permitted on the switch. Note: If 802.1X is enabled, authentication is performed by a RADIUS server. This means the primary authentication method must be RADIUS. To set the method, select Security  Management Security  Authentication List and select RADIUS as method 1 for defaultList. For more information, see Authentication List Configuration on page 198. • Disable. The switch does not check for 802.1X authentication before allowing traffic on any ports, even if the ports are configured to allow only authenticated users. 3. Select the radio button in the VLAN Assignment Mode field. Select Enable and Disable. The default value is Disable. 4. Select the radio button in the Dynamic VLAN Creation Mode field. This lists two options for Dynamic VLAN Creation Mode: Enable and Disable. The default value is Disable. 5. Select the radio button in the EAPOL Flood Mode. This lists two options for EAPOL Flood Mode: Enable and Disable. The default value is Disable. 6. Click Apply. Port Authentication Use the Port Authentication screen to enable and configure port access control on one or more ports.  To configure 802.1X settings for the port: 1. Select Security  Port Authentication > Advanced  Port Authentication. Note: Use the horizontal scroll bar at the bottom of the browser to view all the fields on the Port Authentication screen. The figures on the following screen are both images of the Port Authentication screen. 209