Netgear GS728TXS GS728TXS/GS752TXS Software Administration Manual - Page 314
Sample VLAN Routing Configuration, Basic VLAN, Configuration
View all Netgear GS728TXS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 314 highlights
GS752TXS and GS728TXS Smart Switches Sample VLAN Routing Configuration Complete these steps to configure a switch to perform interVLAN routing. 1. Use the VLAN Configuration screen to enable routing on the switch (see Basic VLAN Configuration on page 103). 2. Determine the IP addresses you want to assign to the VLAN interface on the switch. For the switch to be able to route between the VLANs, the VLAN interfaces must be configured with an IP address. When the switch receives a packet destined for another subnet/VLAN, the switch looks at the routing table to determine where to forward the packet. The packet is then passed to the VLAN interface of the destination. It is then sent to the port where the end device is attached. 3. Configure the VLAN interfaces (by selecting the VLAN; VLANs have to be created statically and ports have to added by using VLAN configuration screens. Refer to the example of configuring VLAN) with the IP address identified using the VLAN Routing Configuration. e.g. IP address 10.1.2.1 and mask 255.255.255.0 4. Repeat this process for all VLANs identified to be configured as the routing interfaces. Note: You can only use the VLAN Routing Wizard for creating VLANs, adding ports, and enabling it for routing by assigning the IP address and mask. 314