Netgear GS728TXS GS728TXS/GS752TXS Software Administration Manual - Page 161

GS752TXS and GS728TXS Smart Switches • Create a LAG, add selected ports to a LAG, then add LAG to the newly created VLAN. • Enable tagging on selected ports if the port is in another VLAN. Disable tagging if a selected port does not exist in another VLAN. • Exclude ports not selected from the VLAN. • Enable routing on the VLAN using the IP address and subnet mask entered.  To configure VLAN routing using the VLAN routing wizard: 1. Click Routing  VLAN > VLAN Routing Wizard. 2. Enter the VLAN Identifier (VID) associated with this VLAN in the Vlan ID field. The range of the VLAN ID is (1 to 4093). The Ports fields displays selectable physical ports (when a unit is selected) and LAGs (if any). Selected ports will be added to the Routing VLAN. Each port has three modes: • T(Tagged). Select the ports on which all frames transmitted for this VLAN will be tagged. The ports that are selected will be included in the VLAN. • U(Untagged). Select the ports on which all frames transmitted for this VLAN will be untagged. The ports that are selected will be included in the VLAN. • BLANK(Autodetect). Select the ports that can be dynamically registered in this VLAN via GVRP. This selection has the effect of excluding a port from the selected VLAN. 3. Define the IP address of the VLAN interface in the IP Address field. 4. Define the subnet mask of the VLAN interface in the Network Mask field. 5. Click Apply. 161