Netgear GS728TXS GS728TXS/GS752TXS Software Administration Manual - Page 272
Factory Default, Upload
View all Netgear GS728TXS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 272 highlights
GS752TXS and GS728TXS Smart Switches The management interface is not available until the switch completes the boot cycle. After the switch resets, the login screen displays. Factory Default Use the Factory Default screen to reset the system configuration to the factory default values. Note: If you reset the switch to the default configuration, the IP address is reset to 192.168.0.239, and the DHCP client is enabled. If you loose network connectivity after you reset the switch to the factory defaults, see Connect the Switch to the Network on page 10. To reset the switch to the factory default settings: 1. Select Maintenance Reset Factory Default. 2. Select the check box on the screen. 3. Click Apply. The switch resets immediately. Upload The switch supports system file uploads from the switch to a remote system by using either TFTP or HTTP. The Upload menu contains links described in the following sections. • TFTP File Upload • HTTP File Upload 272