Sennheiser ADN D1 Instructions for Use - Page 146
Current at PORT I/PORT II of the, Short-circuit at PORT I/PORT II
View all Sennheiser ADN D1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 146 highlights
Using the "Conference Manager" software Column "Description" High Current status: (Port1=ALERT/OK, Port2=ALERT/OK) "Location" [CU Main ######]/ [PS ######] Low Voltage Alert at Unit Pos.### Microphone Limit changed to ## due to number of chairperson units Microphone limit readjusted to max possible value=## Premonition Time readjusted to ##s due to Talk Time Limit conflict Short-Circuit status: (Port1=ALERT/OK, Port2=ALERT/OK) [Unit at Pos.###] [CU Main ######] [CU Main ######] [CU Main ######] [CU Main ######]/ [PS ######] Meaning Current at PORT I/PORT II of the central unit/power supply is within the permissible range ("ok")/too high ("ALERT") Voltage required for powering the conference units is too low Microphone limit has been changed due to changed number of chairperson units Microphone limit has been adjusted to the maximum possible value. Advance warning time has been adjusted due to conflicts with the speaking time limit Short-circuit at PORT I/PORT II of the central unit/power supply ("ALERT")/no short-circuit at PORT I/PORT II of the central unit/power supply("ok") "Error" Column "Description" Cabling error on power supply unit at pos.### (Port##.##) Conference Unit S/N: ###### failure at Pos.###: Please contact service Corrupted USB device CU recording performance problem "Location" [CU Main ######] [CU Main ######] [CU Main ######] [CU Main ######] Insufficient USB device performance [CU Main ######] Invalid USB device format [CU Main ######] No USB device available [CU Main ######] Selftest result: Error [CU Main ######] Set Conference mode=## denied => Value out of range {Automatic=##, Overrun=##, Request=##, Push_To_Talk=##} [CU Main ######] Meaning Faulty system cable connected to power supply Defective conference unit has been detected. Contact your Sennheiser partner (see page 153). Error of the USB mass storage device Performance problem of the CU1. In case of repeated occurrence, contact your Sennheiser partner (see page 153. Read/write speed of the USB mass storage device is not sufficient USB mass storage device uses a file system that is not supported No USB mass storage device available Self-test has failed Conference mode could not be changed ("denied") because the value is out of the permissible range ADN Digital Conference System | 145