Sony DVWM2000 Product Manual (Operation Manual 1st Edition (Revised 6)) - Page 69
Using a single monitor for video and audio, on both player and recorder, Starting automatic editing
View all Sony DVWM2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
Chapter 5 Editing The following figure illustrates this. IN point OUT point Z Playback (recorder) E-E mode (player) Playback (recorder) Using a single monitor for video and audio on both player and recorder For efficient editing if only one monitor is available, use the following method. 1 Connect the monitor to the recorder. 2 In the basic setup menu, set item 008 to AUTO. 3 Press the PLAYER button on the recorder. This forces the recorder to E-E mode, in which the player video and audio signals are output to the monitor. Note In insert editing to tape, it is necessary for audio, video, and CTL signals to be recorded in advance throughout the insert editing section on the tape. If you execute an insert edit over a section where these signals are not present, noise or breakup can occur in the audio and video when that section is played back. Starting automatic editing When you have set the edit points, press the flashing AUTO EDIT button. The AUTO EDIT button changes from flashing to continuously lit, and the automatic editing operation begins. At the end of the editing operation, the AUTO EDIT button goes off. OUT button ENTRY button REVIEW button AUTO EDIT button PREVIEW button To change the OUT point after starting automatic editing operation After starting the automatic editing operation, to end the operation before the preset OUT point, hold down the ENTRY button and press the OUT button. The position where you pressed the button becomes the OUT point, and editing ends. To abandon automatic editing Press the STOP button. The automatic editing operation is abandoned. At the same time, the PREVIEW button and AUTO EDIT button start flashing, and the state before the editing was started is restored. In this case, the IN and OUT points already set are preserved so that you can carry out a preview or automatic editing operation again by pressing the PREVIEW button or AUTO EDIT button. Reviewing the editing results After carrying out an editing operation, you can carry out a review, to check the editing results on the monitor. To carry out a review, after carrying out the edit, and before you set any new edit points or make other settings, press the REVIEW button. The REVIEW button lights, and the review is carried out. At the end of the review the REVIEW button goes off, and the tape returns to the OUT point. 5-9 Chapter 5 Editing