TP-Link OC200 Omada Controller Software 4.1.5Windows/Linux User Guide - Page 130

Chapter 4 Configure the Network with Omada SDN Controller MPPE Encryption Local Networks WAN IP Pool Specify whether to enable MPPE (Microsoft Point-to-Point Encryption) for the tunnel. Encrypted: With Encrypted selected, the PPTP tunnel will be encrypted by MPPE. Unencrypted: With Unencrypted selected, the PPTP tunnel will be not encrypted by MPPE. Select the networks on the local side of the VPN tunnel. The VPN policy will be only applied to the selected local networks. Select the WAN port on which the PPTP VPN tunnel is established. Each WAN port supports only one PPTP VPN tunnel when the gateway works as a PPTP server. Enter the IP address and subnet mask to decide the range of the VPN IP pool. The VPN server will assign IP address to the remote host when the tunnel is established. You can specify any reasonable IP address that will not cause overlap with the IP address of the LAN on the local peer router. 3. Create the VPN users accounts to validate remote hosts in the PPTP User List. Click to load the following page. Username Password Mode Enter the username used for the VPN tunnel. The PPTP client use the username for the validation before accessing the network. Enter the password of user. The PPTP client use the password for the validation before accessing the network. Specify the connection mode for the PPTP users. Client: This mode allows the client to request for an IP address and the server supplies the IP addresses from the VPN IP Pool. With this mode selected, set maximum number of concurrent VPN connections with the same account in Maximum Connections. Network Extension Mode: This mode allows only clients from the configured subnet to connect to the server and obtain VPN services. With this mode selected, specify the subnet in Remote Subnets. 128