TP-Link OC200 Omada Controller Software 4.1.5Windows/Linux User Guide - Page 138
Enter a name to identify the VPN policy and select the purpose as Client-to-Site VPN. Refer
View all TP-Link OC200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 138 highlights
Chapter 4 Configure the Network with Omada SDN Controller • Configuring the gateway as a VPN client using L2TP 1. Go to Settings > VPN. Click to load the following page. 2. Enter a name to identify the VPN policy and select the purpose as Client-to-Site VPN. Refer to the following table to configure the required parameters and click Create. Name Enter a name to identify the VPN policy. Purpose Select the purpose for the VPN as Client-to-Site VPN. VPN Type Select the VPN type as VPN Client - L2TP. Status Click the checkbox to enable the VPN policy. Working Mode Specify the Working Mode as NAT or Routing. NAT: With NAT (Network Address Translation) mode selected, the L2TP client uses the assigned IP address as its source addresses of original IP header when forwarding L2TP packets. Routing: With Routing selected, the L2TP client uses its own IP address as its source addresses of original IP header when forwarding L2TP packets. 136