Yamaha MOTIF7 Owner's Manual - Page 200
F3]-06 Thin Out, F3]-07 Modify Contr, ol Data, F3]-08 Beat Stretch, Modified value, original value
View all Yamaha MOTIF7 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 200 highlights
Song Job mode • Number Of Times Determines the number of times the data creation is to be repeated. For example, if data is created in the range M001:1:000 ~ M003:1:000 and this parameter is set to 03, the same data will be created at M003:1:000 ~ M005:1:000 and M005:1:000 ~ M007:1:000. This Job lets you to insert continuous volume or filter cutoff variations to create tremolo or wow effects. ❏ Settings 01~99 ● [F3]-06 Thin Out This Job thins out the specified type of continuous data in the specified range - allowing you to free up memory space for other data or further recording. Track Range • Event Type Determines the event type to be thinned. ❏ Settings PB (Pitch Bend), CC: 000-127, all (Control Change, Control Change number), CAT (Channel Aftertouch), PAT (Polyphonic Aftertouch) n The Thin Out Job will not work on continuous data that has a clock interval of greater than 60 clocks per event. ● [F3]-07 Modify Control Data This Job lets you change the values of a specified type of control change data - pitch bend, control change, aftertouch, etc. - in the specified range. Data changes are calculated as follows: Modified value = (original value x Rate) + Offset. The modified value cannot exceed the minimum/ maximum limits of the parameter. Any result lower than the minimum is set to the minimum; any result higher than the maximum is set to the maximum. Track Range • Event Type Determines the event type to be modified. ❏ Settings PB (Pitch Bend), CC: 000-127, all (Control Change, Control Change number), CAT (Channel Aftertouch), PAT (Polyphonic Aftertouch), tmp (Tempo) • Set All Sets all target events to the same fixed value. When set to "OFF" the Set All parameter has no effect. When set to a value other than "OFF" the Rate and Offset parameters are unavailable and appear as "***" on the display. ❏ Settings OFF, 000 ~127 (-8192 ~ +8191 for pitch bend, 0.1 ~ 300.0 for tempo) • Rate Determines the percentage by which the target events will be shifted from their original values. When the Set All parameter is not "OFF" this parameter appears as "***" and cannot be changed. ❏ Settings 000% ~ 200%, *** • Offset Adds a fixed value to the Rate-adjusted event values. When the Set All parameter is not "OFF" this parameter appears as "***" and cannot be changed. ❏ Settings -127~127, *** (-8192 ~ +8191 for pitch bend, ***) ● [F3]-08 Beat Stretch This Job performs time-expansion or compression over the selected range. Keep in mind that this operation affects all event timing, note step times, and note gate times. Track Range • Rate Determines the amount of time expansion or compression as a percentage. Settings higher than 100% produce expansion, and settings below 100% produce compression. ❏ Settings 025%~400% n Only MIDI data is affected by this job. Sample voices are not expanded or compressed. However, for samples recorded using the Slice+Seq feature, the Beat Stretch job expands or compresses the timing of the note data, step times, and gate times that control playback of the sliced samples. The sample voice itself is not affected. Reference Song mode 200 MOTIF Reference