Yamaha MOTIF7 Owner's Manual - Page 280

Troubleshooting Pitch or intervals are wrong. • Is the Master Tune parameter in the Utility mode set at a value other than "0"? page 250 • Is the Note Shift parameter in the Utility mode set at a value other than "0"? page 250 • When the voice produces a wrong pitch, is the appropriate tuning system selected from Micro Tuning parameter in the Voice Edit mode? page 130 • When the voice produces a wrong pitch, is the LFO Pitch Modulation Depth in the Voice Edit mode set too high? page 147 • When the performance produces a wrong pitch, is the Note Shift parameter of each part set at a value other than "0"? page 173 • When the performance produces a wrong pitch, is the Detune parameter of each part set at a value other than "0"? page 173 • When the song/pattern playback produces a wrong pitch, is the Note Offset parameter in the Groove display set at a value other than "0"? pages 181, 218 Only one note sounds at a time. • Is the Mono/Poly parameter in the Voice mode set to "mono"? page 130 No effect is applied. • Is the [EFFECT BYPASS] button turned off? • Have the [REVERB] and [CHORUS] buttons been turned fully counter-clockwise (to the minimum)? • Have any or all of the elements' Effect Output parameter been set to "thru"? • Have any or all of the effect types been set to "thru" or "off" (in the Effect display of the Voice Edit mode)? page 13 pages 48, 84 page 137 page 137 Song/Pattern cannot be started. • Does the selected song or pattern (phrase) contain data? • Is the Remote Control turned on? • Is the MIDI sync parameter set to MIDI (using external clock) in the Utility mode? pages 179, 217 page 13 page 258 Song/Pattern (Phrase) cannot be recorded. • Is there enough free memory for recording? The total MOTIF memory capacity determines the number of songs/patterns (phrases) that can be recorded. For example, if the memory contains songs/patterns (phrases) that use up a large amount of memory, the memory may become full even though the available pattern or song numbers are not all used. pages 275, 276 • In the Pattern Record mode, does the specified track to which the Phrase is assigned have preset data? Recording cannot be done to a track that contains preset data. page 221 Can't record samples. • Have you exceeded the maximum allowable number of samples (key banks)? • Is there enough free sample memory? • Is the Sampling Source setting appropriate? • Is the Trigger mode set appropriately? page 60 page 276 page 236 page 237 Can't save data to the Memory card or the SCSI disk. • Is the Memory card or SCSI disk being used write protected? (Write-protect should be set to off for saving data.) • Is the Memory card or SCSI disk being used properly formatted? pages 289, 290 page 265 MIDI bulk data transmission/reception won't work properly. • Is the Receive Bulk parameter set to "protect" in the Utility mode? page 258 Plug-in board does not work. • Is the lamp of the corresponding slot number to which the Plug-in board has been installed lit? page 87 • Has the Vocal Harmony Plug-in board been installed to slot 2 or 3 ? (The VH board should be installed to slot 1.) page 282 • Has the Multi-part Plug-in board been installed to slot 1 or 2 ? (The Multi-part Plug-in board should be installed to slot 3.) page 282 Appendix 280 MOTIF Appendix