Yamaha MOTIF7 Owner's Manual - Page 285

5 Remove the AIEB2 power cables from the hookshaped cable clip in the MOTIF. MOTIF6 / MOTIF7 Top (keyboard side) of the MOTIF Underside of the MOTIF Rear panel of the MOTIF MOTIF8 Top (keyboard side) of the MOTIF Installing Optional Hardware 7 Connect the flat ribbon cable coming from AIEB2 to the circuit board of the MOTIF. Be careful to connect in the proper direction as shown. Make sure that the direction is correct and do not try to force the connection. Flat ribbon cable of the AIEB2 Align the connectors as shown. Connector on the circuit board of the MOTIF m-LAN CN5 Unlatch the cable clip by pulling out the tab as shown. Replace the clip after pulling out the power cable. Underside of the MOTIF Rear panel of the MOTIF 6 Remove the AIEB2 from its package. The AIEB2 has one flat ribbon cable and two power cables. Since these two power cables are used for the main body and are not needed when installing to the MOTIF, you can remove them from the AIEB2. AIEB2 Remove the two power cables. Rear panel of the MOTIF AIEB2 8 Connect the power cable coming from MOTIF to the AIEB2. Connect the 3-pin cable to the CN3 connector of the AIEB2, and the 4-pin cable to the CN1 connector. m-LAN CN5 Connect the 4-pin cable to the CN1 connector Connect the 3-pin cable to the CN3 connector * Make sure to properly match the cables and connectors. Avoid applying excessive force when connecting. 9 Fasten the AIEB2 to the MOTIF. Flip the unit over, so that the bottom of the plate can be seen, and that each connector section of the AIEB2 can be seen from the back side of MOTIF. Supporting the unit with one hand, attach it to the rear of the MOTIF with the three screws you removed in step 4. If you start replacing the screws from the center screw, it will be easy to replace the remaining screws. MOTIF Appendix 285 Appendix