Yamaha MOTIF7 Owner's Manual - Page 254

Utility mode • Freq (Frequency) Set the center frequency. Frequencies around this point are attenuated/boosted by the Gain setting. ❏ Settings LOW (Low range) Peaking 63Hz ~ 2.0kHz Shelving 32Hz ~ 2.0kHz LOW MID (Low middle range) 100Hz~10kHz MID (Middle range)100Hz~10kHz HIGH MID (High middle range) 100Hz ~10kHz HIGH (High range)500Hz~16kHz • Gain Determines the level gain for the Frequency (set above), or the amount the selected frequency band is attenuated or boosted. ❏ Settings -12dB~0dB~+12dB • Q (Frequency Characteristic) This varies the signal level at the Frequency setting to create various frequency curve characteristics. ❏ Settings 0.1~12.0 ● [F3]-[SF2] Voice Arpeggio Channel From this display you can set parameters related to output of the Arpeggio MIDI data. • OutputSwitch This enables or disables MIDI data output for the Arpeggio function. When this is set to "on," Arpeggio data is sent via MIDI - allowing you to send the Arpeggio data to an external sequencer or play back the Arpeggios on connected MIDI tone generators. ❏ Settings on (enable), off (disable) • TransmitCh (Transmit channel) Determines the MIDI channel through which Arpeggio playback data will be sent (when Output Switch above is on). ❏ Settings 1~16 ● [F3]-[SF3] Voice Controller Assign Sets the parameters related to the controllers in the Voice mode. Details about each parameter are same as in Performance Common Edit. See page 169 . Knob Assign 1, 2 Foot Controller 1, 2 [F3] Sequencer settings These special song- and pattern-related settings are available only when entering the Utility mode from the Song or Pattern mode. ● [F3]-[SF1] Sequencer Click (MIDI Click) From this display you can set the parameters related to the click sound (metronome) that is used during recording or playback in the Song/Pattern mode. • Mode Determines whether and when the metronome click will sound. ❏ Settings off, rec, rec/play, all off The click will not sound. rec The click will sound during recording only. rec/play The click will sound during recording and playback. all The click will always sound. • Beat Determines on which beats the metronome click will sound. ❏ Settings 16 (16th notes), 08 (8th notes), 04 (quarter notes), 02 (half notes), 01 (whole notes) • Volume Determines the click sound volume. ❏ Settings 0~127 • Rec Count Sets the number of count-in measures provided before actually recording starts after pressing the [F] button in the Record standby mode . ❏ Settings off (Recording starts as soon as the [F] button is pressed ), 1meas~8meas n Since the click sound is created with the internal tone generator, using click playback affects the overall polyphony of the MOTIF. Reference Utility mode Breath Controller ❏ Settings off, 0~95 254 MOTIF Reference