Yamaha MOTIF7 Owner's Manual - Page 255
F4] Controller settings, Interval Time
View all Yamaha MOTIF7 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 255 highlights
● [F3]-[SF2] Sequencer MIDI Filter From this display you can set which MIDI events will be recognized/transmitted via the MIDI IN/ OUT terminal or the USB terminal. The settings made here apply only to song/pattern playback data; they do not affect the MIDI events generated by your keyboard polaying or panel operations in the Voice and Performance modes. ● [F3]-[SF3] Sequencer Other • PtnQuantize (Pattern Quantize) Determines the quantize value for pattern switching during playback. When set to "1," patterns (sections) will always switch on the first beat of the measure during playback. When "1/16" is selected, patterns (sections) can be switched on any 16th beat during playback. ❏ Settings 1 (1 measure), 1/2 (Half note), 1/4(Quarter note), 1/8(8th note), 1/16 (16th note) • PtnTempoHold (Pattern Tempo Hold) Determines whether or not the tempo setting will switch to the tempo value stored with each style when a new style is selected during playback. When set to "on," the tempo will be retained when styles are switched. When set to "off," the tempo will switch to that stored with the new style when styles are switched. ❏ Settings on, off n The tempo setting data in the Pattern Chain is not affected by this parameter. • SongEventChase Event Chase allows you to specify which non-note data types are properly recognized during fast-forward and rewind operations. Normally, if a song or pattern is played back from mid-point and/or fast-forward or rewind are used, certain data types (such as Program Change, Pitch Bend, and Control Change) may not play back as expected. Setting this to a specific event ensures the playback "integrity" of the event, even when fast-forwarding or rewinding. ❏ Settings Off, PC (Program Change), PC+PB+Ctrl (Program Change+Pitch Bend+Control Change), All (All events) Utility mode n Keep in mind that settings other than "off" may result in slower operation - for example, a pause before starting playback, or slower rewind/fastforward speed. n When this is set to "All," an excessive amount of MIDI data may be generated, possibly resulting in a MIDI error on the connected device. • DumpExIntrval (Bulk Dump Exclusive Interval Time) When playing back system exclusive data (bulk data) that is recorded on the sequence tracks, this sets the interval that is inserted for each 1KB. When sending bulk data from the MOTIF to a connected MIDI device, a MIDI error may result if the device cannot handle large amounts of data in a short time. This parameter compensates for that by setting an interval that provides enough time for the receiving device to process the bulk data. ❏ Settings 0~900 (msec) n The playback may be a little slower depending on the currently set interval. Also when a MIDI error occurs, try to set the interval a little higher and send the data again. • LoadMix Determines whether the Mixing settings are loaded (on) or not (off) when the Song/Style number is changed. ❏ Settings off, on n This setting affects the Song/Pattern change during the Song/Pattern chain playback. • SendXGon Determines whether the XG reset message is sent to the Multi-part Plug-in board tone generator block (on) or not (off) when starting the XG song or changing the Song/ Style number. ❏ Settings on, off [F4] Controller settings ● [F4]-[SF1] Controller Assign Arpeggio • Switch Determines the Control Change Number that controls the Arpeggio playback on/off. ❏ Settings off, 01~95 • Hold Determines the Control Change Number that controls the Arpeggio Hold (page 129) on/off. ❏ Settings off, 01~95 Reference Utility mode MOTIF Reference 255