Yamaha MOTIF7 Owner's Manual - Page 288
SIMM Installation, Location for SIMM Installation, Installing the SIMM modules to the sockets
View all Yamaha MOTIF7 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 288 highlights
Installing Optional Hardware 4MB X 2 8MB X 2 Internal memory 4MB 12MB can be used for sampling. 16MB X 2 Internal memory 4MB 20MB can be used for sampling. 32MB X 2 Installing the SIMM modules to the sockets Tilt the SIMM and insert it into the socket. Cutout Push the SIMM up vertically. Internal memory 4MB Internal memory 4MB 36MB can be used for sampling. 64MB can be used for sampling. • Yamaha recommends that you purchase SIMMs that conform to the JEDEC* standard. Please be aware, however, that conformance to this standard does not constitute a guarantee that the SIMMs will operate correctly on the MOTIF. • JEDEC (Joint Electron Device Engineering Council) sets standards for terminal configurations within electronic devices. n Make sure that the SIMM is securely inserted in the socket of the MOTIF. Inserting the SIMM improperly or incompletely may result in faulty operation. * To remove the SIMM, gently but firmly pull the fastening clips open, then tilt the SIMM back and pull it out. Pull open these clips. Pull open these clips. SIMM Installation 1 Use the same operation as in "Installing the AIEB2." 2 On the SIMM, there is a cut in the board next to the 1PIN. Insert the board into the socket so that the 1PIN lines up with the 1PIN mark (▲) printed on the board. 72PIN SIMM Cutout Location for SIMM Installation to PNA 4 CN24 11 to JK CN25 to PS 4 CN23 1PIN mark SIMM sockets Underside of the MOTIF Rear panel of the MOTIF Tilt the SIMM module and pull it out. 3 Set the SIMM into the socket at an angle as shown in the illustration above (1). Then push the SIMM upright until it clicks into the position shown in figure 4 Insert the remaining SIMM into the remaining socket. 5 Re-install the cover you removed in earlier steps, in reverse order. 6 Check that the installed SIMMs are functioning properly. Set the MOTIF right-side up, and connect the power cord to the rear-panel AC INLET jack and an AC outlet. Turn on the power, go to the SAMPLING display, and press the [INFORMATION] button (page 276). If the SIMMs have been installed properly, the appropriate available memory size is indicated in the display. 288 MOTIF Appendix Appendix