ZyXEL ZyWALL 5 User Guide - Page 118

Chapter 5 Tutorials 3 Open a web browser (like Internet Explorer) to connect to the ZyWALL P1's LAN IP address (http://192.168.167.1 in this example). 4 The user mode screen for VPN authentication displays. Enter the user name "SalesManager" and password "Manager1234". Click Activate. 5 ZyWALL B automatically initiates and negotiates the VPN tunnel with ZyWALL A after you pass the authentication. A successful screen displays. Click Return. 6 Send a ping from the telecommuter's computer (IP address 192.168.167.2) to a device on the office network (X), for example 10.0.0.2. You should get a response. To do this in most Windows computers, click Start > Run, enter cmd, and then enter ping followed by the IP address of a computer on network X. Here is an example. Figure 51 Telecommuter Pinging a Network X IP Address Example C:\>ping 10.0.0.2 Pinging 10.0.0.2 with 32 bytes of data: Reply from 10.0.0.2: bytes=32 time=3ms TTL=126 Reply from 10.0.0.2: bytes=32 time=2ms TTL=126 Reply from 10.0.0.2: bytes=32 time=2ms TTL=126 Reply from 10.0.0.2: bytes=32 time=2ms TTL=126 Ping statistics for 10.0.0.2: Packets: Sent = 4, Received = 4, Lost = 0 (0% loss), Approximate round trip times in milli-seconds: Minimum = 2ms, Maximum = 3ms, Average = 2ms If there is no reply to the ping, the system log can help identify a configuration problem. Click LOGS to see the system log. See Section on page 561 for information on the log messages. You may need to click LOGS > Log Settings in the advanced web configurator and make sure IKE and IPSec logging is enabled at both ends. You can clear the existing log and reattempt to build the tunnel (this makes it easier to identify the relevant logs). 118 ZyWALL 5/35/70 Series User's Guide