ZyXEL ZyWALL 5 User Guide - Page 666
Edit Filter Sets, Menu 11.1.4 - Remote Node Filter
View all ZyXEL ZyWALL 5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 666 highlights
Chapter 42 Remote Node Setup Table 238 Remote Node Network Layer Options Menu Fields (continued) FIELD DESCRIPTION NAT Lookup Set If you select SUA Only in the Network Address Translation field, it displays 255 and indicates the SMT will use the pre-configured Set 255 (read only) in menu 15.1. If you select Full Feature or None in the Network Address Translation field, it displays 1, 2 or 3 and indicates the SMT will use the pre-configured Set 1 in menu 15.1 for the first WAN port, Set 2 in menu 15.1 for the second WAN port and Set 3 for the Backup port. Refer to Section 44.2 on page 675 for more information. Metric Enter a number from 1 to 15 to set this route's priority among the ZyWALL's routes (see Section on page 171). The smaller the number, the higher priority the route has. Private This field is valid only for PPTP/PPPoE encapsulation. This parameter determines if the ZyWALL will include the route to this remote node in its RIP broadcasts. If set to Yes, this route is kept private and not included in RIP broadcast. If No, the route to this remote node will be propagated to other hosts through RIP broadcasts. RIP Direction Press [SPACE BAR] and then [ENTER] to select the RIP direction from Both/ None/In Only/Out Only. See Chapter 7 on page 149 for more information on RIP. The default for RIP on the WAN side is None. It is recommended that you do not change this setting. Version Press [SPACE BAR] and then [ENTER] to select the RIP version from RIP-1/RIP-2B/ RIP-2M or None. Multicast IGMP (Internet Group Management Protocol) is a network-layer protocol used to establish membership in a Multicast group. The ZyWALL supports both IGMP version 1 (IGMP-v1) and version 2 (IGMP-v2). Press [SPACE BAR] to enable IP Multicasting or select None to disable it. See Chapter 7 on page 149 for more information on this feature. Once you have completed filling in Menu 11.3 Remote Node Network Layer Options, press [ENTER] at the message "Press ENTER to Confirm..." to save your configuration and return to menu 11, or press [ESC] at any time to cancel. 42.5 Remote Node Filter Move the cursor to the field Edit Filter Sets in menu 11.1, and then press [SPACE BAR] to set the value to Yes. Press [ENTER] to open Menu 11.1.4 - Remote Node Filter. Use menu 11.1.4 to specify the filter set(s) to apply to the incoming and outgoing traffic between this remote node and the ZyWALL to prevent certain packets from triggering calls. You can specify up to 4 filter sets separated by commas, for example, 1, 5, 9, 12, in each filter field. Note that spaces are accepted in this field. For more information on defining the filters, please refer to Chapter 46 on page 695. For PPPoE or PPTP encapsulation, you have the additional option of specifying remote node call filter sets. 666 ZyWALL 5/35/70 Series User's Guide