ZyXEL ZyWALL ATP700 User Guide - Page 218
Configuration > Wireless > AP Management > Mgnt. AP List continued
View all ZyXEL ZyWALL ATP700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 218 highlights
Chapter 8 Wireless Table 84 Configuration > Wireless > AP Management > Mgnt. AP List (continued) LABEL DESCRIPTION Reboot device Select one or multiple APs and click this button to force the AP(s) to restart. Remove the selected rule Select one or multiple APs and click this button to remove the AP(s) from the manged AP list. DCS Now Note: If on the Configuration > Wireless > Controller screen you set the Registration Type to Always Accept, then as soon as you remove an AP from this list it reconnects. Select one or multiple APs and click this button to use DCS (Dynamic Channel Selection) to allow the AP to automatically find a less-used channel in an environment where there are many APs and there may be interference. Note: You should have enabled DCS in the applied AP radio profile before the APs can use DCS. More Information Radio Information Query Controller Log Nebula Note: DCS is not supported on the radio which is working in repeater AP mode. Select an AP and click this to view a daily station count about the selected AP. The count records station activity on the AP over a consecutive 24 hour period. Select an online AP and click this button to go to the Monitor > Wireless > AP Information > Radio List screen to view detailed information about the AP's radios. Select one or multiple APs and click this button to go to the Monitor > Log > View Log screen to view the selected AP's current log messages. Select an AP and click this to open a screen where you can set whether the AP's IP address and VLAN settings will be changed when it goes into Nebula cloud management mode. Upgrade Firmware Now Suppression On Suppression Off Locator On # Status Description Note: The AP will be set to Nebula cloud management mode and removed from the managed AP list right after you click OK. Select one or more APs and click this button to update the APs' firmware version. Select an AP and click this button to enable the AP's LED suppression mode. All the LEDs of the AP will turn off after the AP is ready. This button is not available if the selected AP doesn't support suppression mode. Select an AP and click this button to disable the AP's LED suppression mode. The AP LEDs stay lit after the AP is ready. This button is not available if the selected AP doesn't support suppression mode. Select an AP and click this button to run the locator feature. The AP's Locator LED will start to blink for 10 minutes by default. It will show the actual location of the AP between several devices on the network. This field is a sequential value, and it is not associated with any entry. This field displays the status of AP. • Online All • Online • Conflict • Non Support • Updating • Offline All • Offline • Offline for Firmware Update • Update • Un-Mgmt This field displays the AP's description, which you can configure by selecting the AP's entry and clicking the Edit button. ZyWALL ATP Series User's Guide 218