ZyXEL ZyWALL ATP700 User Guide - Page 307
Bridge Add/Edit
View all ZyXEL ZyWALL ATP700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 307 highlights
Chapter 9 Interfaces Each field is described in the following table. Table 118 Configuration > Network > Interface > Bridge LABEL DESCRIPTION Configuration / IPv6 Configuration Use the Configuration section for IPv4 network settings. Use the IPv6 Configuration section for IPv6 network settings if you connect your Zyxel Device to an IPv6 network. Both sections have similar fields as described below. Add Edit Click this to create a new entry. Double-click an entry or select it and click Edit to open a screen where you can modify the entry's settings. Remove To remove an entry, select it and click Remove. The Zyxel Device confirms you want to remove it before doing so. Activate Inactivate To turn on an entry, select it and click Activate. To turn off an entry, select it and click Inactivate. Create Virtual Interface To open the screen where you can create a virtual interface, select an interface and click Create Virtual Interface. References # Select an entry and click References to open a screen that shows which settings use the entry. See Section 9.4.4 on page 265 for an example. This field is a sequential value, and it is not associated with any interface. Status Name This icon is lit when the entry is active and dimmed when the entry is inactive. This field displays the name of the interface. Description This field displays the description of the interface. IP Address This field displays the current IP address of the interface. If the IP address is 0.0.0.0, the interface does not have an IP address yet. This screen also shows whether the IP address is a static IP address (STATIC) or dynamically assigned (DHCP). IP addresses are always static in virtual interfaces. Member This field displays the Ethernet interfaces and VLAN interfaces in the bridge interface. It is blank for virtual interfaces. Apply Click Apply to save your changes back to the Zyxel Device. Reset Click Reset to return the screen to its last-saved settings. 9.9.2 Bridge Add/Edit This screen lets you configure IP address assignment, interface bandwidth parameters, DHCP settings, and connectivity check for each bridge interface. To access this screen, click the Add or Edit icon on the Bridge Summary screen. The following screen appears. ZyWALL ATP Series User's Guide 307