ZyXEL ZyWALL ATP700 User Guide - Page 828
Label, Description
View all ZyXEL ZyWALL ATP700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 828 highlights
Chapter 38 Log and Report Figure 576 Configuration > Log & Report > Log Setting > Edit (System Log - AP) The following table describes the labels in this screen. Table 354 Configuration > Log & Report > Log Setting > Edit (System Log) LABEL DESCRIPTION E-Mail Server 1/2 Active Mail Server Mail Server Port Mail Subject Send From Send Log To Send Alerts To Sending Log Day for Sending Log Time for Sending Log SMTP Authentication User Name Password Retype to Confirm Active Log and Alert System Log Select this to send log messages and alerts according to the information in this section. You specify what kinds of log messages are included in log information and what kinds of log messages are included in alerts in the Active Log and Alert section. Type the name or IP address of the outgoing SMTP server. Enter the same port number here as is on the mail server for mail traffic. Type the subject line for the outgoing email. Type the email address from which the outgoing email is delivered. This address is used in replies. Type the email address to which the outgoing email is delivered. Type the email address to which alerts are delivered. Select how often log information is emailed. Choices are: When Full, Hourly and When Full, Daily and When Full, and Weekly and When Full. This field is available if the log is emailed weekly. Select the day of the week the log is emailed. This field is available if the log is emailed weekly or daily. Select the time of day (hours and minutes) when the log is emailed. Use 24-hour notation. Select this check box if it is necessary to provide a user name and password to the SMTP server. This box is effective when you select the SMTP Authentication check box. Type the user name to provide to the SMTP server when the log is emailed. This box is effective when you select the SMTP Authentication check box. Type the password of up to 63 characters to provide to the SMTP server when the log is emailed. Type the password again to make sure that you have entered is correctly. Use the System Log drop-down list to change the log settings for all of the log categories. disable all logs (red X) - do not log any information for any category for the system log or email any logs to email server 1 or 2. enable normal logs (green check mark) - create log messages and alerts for all categories for the system log. If email server 1 or 2 also has normal logs enabled, the Zyxel Device will email logs to them. enable normal logs and debug logs (yellow check mark) - create log messages, alerts, and debugging information for all categories. The Zyxel Device does not email debugging information, even if this setting is selected. ZyWALL ATP Series User's Guide 828