ZyXEL ZyWALL ATP700 User Guide - Page 342
Routing, ZyWALL ATP Series User's Guide, Table 130, Configuration > Network >
View all ZyXEL ZyWALL ATP700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 342 highlights
Chapter 10 Routing Table 130 Configuration > Network > Routing > Policy Route > Add/Edit (continued) LABEL DESCRIPTION DSCP Code Select a DSCP code point value of incoming packets to which this policy route applies or select User Define to specify another DSCP code point. The lower the number the higher the priority with the exception of 0 which is usually given only best-effort treatment. any means all DSCP value or no DSCP marker. default means traffic with a DSCP value of 0. This is usually best effort traffic User-Defined DSCP Code Schedule Service Source Port Next-Hop Type The "af" choices stand for Assured Forwarding. The number following the "af" identifies one of four classes and one of three drop preferences. See Assured Forwarding (AF) PHB for DiffServ for more details. Use this field to specify a custom DSCP code point when you select User Define in the previous field. Select a schedule to control when the policy route is active. none means the route is active at all times if enabled. Select a service or service group to identify the type of traffic to which this policy route applies. Select a service or service group to identify the source port of packets to which the policy route applies. Select Auto to have the Zyxel Device use the routing table to find a next-hop and forward the matched packets automatically. Select Gateway to route the matched packets to the next-hop router or switch you specified in the Gateway field. You have to set up the next-hop router or switch as a HOST address object first. Select VPN Tunnel to route the matched packets via the specified VPN tunnel. Select Trunk to route the matched packets through the interfaces in the trunk group based on the load balancing algorithm. Gateway VPN Tunnel Auto Destination Address Select Interface to route the matched packets through the specified outgoing interface to a gateway (which is connected to the interface). This field displays when you select Gateway in the Type field. Select a HOST address object. The gateway is an immediate neighbor of your Zyxel Device that will forward the packet to the destination. The gateway must be a router or switch on the same segment as your Zyxel Device's interface(s). This field displays when you select VPN Tunnel in the Type field. Select a VPN tunnel through which the packets are sent to the remote network that is connected to the Zyxel Device directly. This field displays when you select VPN Tunnel in the Type field. Select this to have the Zyxel Device use the local network of the peer router that initiated an incoming dynamic IPSec tunnel as the destination address of the policy. Trunk Interface Leave this cleared if you want to manually specify the destination address. This field displays when you select Trunk in the Type field. Select a trunk group to have the Zyxel Device send the packets via the interfaces in the group. This field displays when you select Interface in the Type field. Select an interface to have the Zyxel Device send traffic that matches the policy route through the specified interface. ZyWALL ATP Series User's Guide 342