ZyXEL ZyWALL ATP700 User Guide - Page 244

Chapter 9 Interfaces The physical Ethernet ports are shown at the top and the Ethernet interfaces and zones are shown at the bottom of the screen. Use the radio buttons to select for which interface (network) you want to use each physical port. For example, select a port's LAN radio button to use the port as part of the LAN interface. The port will use the Zyxel Device's LAN IP address and MAC address. When you assign more than one physical port to a network, you create a port group. Port groups have the following characteristics: • There is a layer-2 Ethernet switch between physical ports in the port group. This provides wire-speed throughput but no security. • It can increase the bandwidth between the port group and other interfaces. • The port group uses a single MAC address. Click Apply to save your changes and apply them to the Zyxel Device. Click Reset to change the port groups to their current configuration (last-saved values). 9.3 Port Configuration Use this screen to configure port settings. Click Configuration > Network > Interface > Port Configuration in the navigation panel to display the configuration screen. Note: You cannot configure the speed and duplex mode of fiber ports. Figure 194 Configuration > Network > Interface > Port Configuration ZyWALL ATP Series User's Guide 244