ZyXEL ZyWALL ATP700 User Guide - Page 223

Chapter 8 Wireless Each field is described in the following table. Table 86 Configuration > Wireless > AP Management > AP Policy LABEL DESCRIPTION Force Override AC IP Config on AP Override Type Select this to have the Zyxel Device change the AP controller's IP address on the managed AP(s) to match the configuration in this screen. Select Auto to have the managed AP(s) automatically send broadcast packets to find any other available AP controllers. Select Manual to replace the AP controller's IP address configured on the managed AP(s) with the one(s) you specified below. Primary Controller Specify the IP address of the primary AP controller if you set Override Type to Manual. Secondary Controller Specify the IP address of the secondary AP controller if you set Override Type to Manual. Fall back to Primary Controller when possible Select this option to have the managed AP(s) change back to associate with the primary AP controller as soon as the primary AP controller is available. Fall Back Check Interval Set how often the managed AP(s) check whether the primary AP controller is available. Firmware Updating Updating Type Specify how you want the Zyxel Device to upgrade AP firmware. Select CAPWAP to have the Zyxel Device use CAPWAP (Control and Provisioning of Wireless Access Points protocol) to automatically update firmware on the managed APs. Apply Reset Select FTP to allow the managed APs to download the latest firmware from the Zyxel Device using FTP. Click Apply to save your changes back to the Zyxel Device. Click Reset to return the screen to its last-saved settings. 8.4.3 AP Group Use this screen to configure AP groups, which define the radio, port, VLAN and load balancing settings and apply the settings to all APs in the group. An AP can belong to one AP group at a time. Click Configuration > Wireless > AP Management > AP Group to access this screen. Figure 182 Configuration > Wireless > AP Management > AP Group ZyWALL ATP Series User's Guide 223