ZyXEL ZyWALL ATP700 User Guide - Page 42
Introduction, ZyWALL ATP Series User's Guide, Table 7, Configuration Menu Screens Summary
View all ZyXEL ZyWALL ATP700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Chapter 1 Introduction Table 7 Configuration Menu Screens Summary (continued) FOLDER OR LINK TAB FUNCTION Interface Port Port Role/Port Configuration Use this screen to set the Zyxel Device's flexible ports such as LAN, OPT, WLAN, or DMZ. Ethernet Manage Ethernet interfaces and virtual Ethernet interfaces. PPP Create and manage PPPoE and PPTP interfaces. Cellular Configure a cellular Internet connection for an installed mobile broadband card. Tunnel Configure tunneling between IPv4 and IPv6 networks. VLAN Create and manage VLAN interfaces and virtual VLAN interfaces. Bridge Create and manage bridges and virtual bridge interfaces. VTI Configure IP address assignment and interface parameters for VTI (Virtual Tunnel Interface). Trunk Create and manage trunks (groups of interfaces) for load balancing. Routing Policy Route Create and manage routing policies. Static Route Create and manage IP static routing information. RIP Configure device-level RIP settings. OSPF Configure device-level OSPF settings, including areas and virtual links. BGP Configure exchange of Border Gateway Protocol (BGP) information over an IPSec tunnel. DDNS DDNS Define and manage the Zyxel Device's DDNS domain names. NAT NAT Set up and manage port forwarding rules. Redirect Service Redirect Service Set up and manage HTTP and SMTP redirection rules. ALG ALG Configure SIP, H.323, and FTP pass-through settings. UPnP UPnP Configure interfaces that allow UPnP and NAT-PMP connections. IP/MAC Binding Summary Configure IP to MAC address bindings for devices connected to each supported interface. Exempt List Configure ranges of IP addresses to which the Zyxel Device does not apply IP/MAC binding. Layer 2 Isolation General Enable layer-2 isolation on the Zyxel Device and the internal interface(s). White List Enable and configure the white list. DNS Inbound LB DNS Load Balancing Configure DNS Load Balancing. VPN IPSec VPN VPN Connection Configure IPSec tunnels. VPN Gateway Configure IKE tunnels. Concentrator Combine IPSec VPN connections into a single secure network Configuration Provisioning Set who can retrieve VPN rule settings from the Zyxel Device using the Zyxel Device IPSec VPN Client. SSL VPN Access Privilege Configure SSL VPN access rights for users and groups. Global Setting Configure the Zyxel Device's SSL VPN settings that apply to all connections. L2TP VPN L2TP VPN Configure L2TP over IPSec tunnels. BWM BWM Enable and configure bandwidth management rules. ZyWALL ATP Series User's Guide 42