ZyXEL ZyWALL ATP700 User Guide - Page 270
PPP Interface Add or Edit
View all ZyXEL ZyWALL ATP700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 270 highlights
Chapter 9 Interfaces Each field is described in the table below. Table 106 Configuration > Network > Interface > PPP LABEL DESCRIPTION User Configuration / System Default The Zyxel Device comes with the (non-removable) System Default PPP interfaces preconfigured. You can create (and delete) User Configuration PPP interfaces. System Default PPP interfaces vary by model. Add Edit Click this to create a new user-configured PPP interface. Double-click an entry or select it and click Edit to open a screen where you can modify the entry's settings. Remove To remove a user-configured PPP interface, select it and click Remove. The Zyxel Device confirms you want to remove it before doing so. Activate Inactivate To turn on an entry, select it and click Activate. To turn off an entry, select it and click Inactivate. Connect To connect an interface, select it and click Connect. You might use this in testing the interface or to manually establish the connection for a Dial-on-Demand PPPoE/PPTP interface. Disconnect References To disconnect an interface, select it and click Disconnect. You might use this in testing the interface. Select an entry and click References to open a screen that shows which settings use the entry. See Section 9.4.4 on page 265 for an example. # This field is a sequential value, and it is not associated with any interface. Status The activate (light bulb) icon is lit when the entry is active and dimmed when the entry is inactive. The connect icon is lit when the interface is connected and dimmed when it is disconnected. Name This field displays the name of the interface. Description This field displays the description of the interface. Base Interface This field displays the interface on the top of which the PPPoE/PPTP/L2TP interface is. Account Profile Apply This field displays the ISP account used by this PPPoE/PPTP interface. Click Apply to save your changes back to the Zyxel Device. Reset Click Reset to return the screen to its last-saved settings. 9.5.2 PPP Interface Add or Edit Note: You have to set up an ISP account before you create a PPPoE/PPTP/L2TP interface. This screen lets you configure a PPPoE or PPTP or L2TP interface. If you enabled IPv6 on the Configuration > System > IPv6 screen, you can also configure PPP interfaces used for your IPv6 networks on this screen. To access this screen, click the Add icon or an Edit icon on the PPP Interface screen. ZyWALL ATP Series User's Guide 270