ZyXEL ZyWALL ATP700 User Guide - Page 304
Bridge Interfaces
View all ZyXEL ZyWALL ATP700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 304 highlights
Chapter 9 Interfaces Table 114 Configuration > Network > Interface > VLAN > Add / Edit (continued) LABEL DESCRIPTION MAC Address Setting This section appears when Interface Properties is External or General. Have the interface use either the factory assigned default MAC address, a manually specified MAC address, or clone the MAC address of another device or computer. Use Default MAC Select this option to have the interface use the factory assigned default MAC address. By Address default, the Zyxel Device uses the factory assigned MAC address to identify itself. Overwrite Default MAC Address Select this option to have the interface use a different MAC address. Either the MAC address in the field. Once it is successfully configured, the address will be copied to the configuration file. It will not change unless you change the setting or upload a different configuration file. Proxy ARP Proxy ARP is available for external or general interfaces on the Zyxel Device. See Section on page 254 for more information on Proxy ARP. Enable Proxy ARP Select this to allow the Zyxel Device to answer external interface ARP requests on behalf of a device on its internal interface. Interfaces supported are: Add • Ethernet • VLAN • Bridge See Section 9.4.2 on page 263 for more information. Click Add to create an IPv4 Address, an IPv4 CIDR (for example, 192.168.1.1/24) or an IPv4 Range (for example, 192.168.1.2-192.168.1.100) as the target IP address. The Zyxel Device answers external ARP requests only if they match one of these inputted target IP addresses. For example, if the IPv4 Address is 192.168.1.5, then the Zyxel Device will answer ARP requests coming from the WAN only if it contains 192.168.1.5 as the target IP address. Select an existing entry and click Remove to delete that entry. Related Setting Configure WAN TRUNK Configure Policy Route OK Cancel Click WAN TRUNK to go to a screen where you can set this VLAN to be part of a WAN trunk for load balancing. Click Policy Route to go to the screen where you can manually configure a policy route to associate traffic with this VLAN. Click OK to save your changes back to the Zyxel Device. Click Cancel to exit this screen without saving. 9.9 Bridge Interfaces This section introduces bridges and bridge interfaces and then explains the screens for bridge interfaces. ZyWALL ATP Series User's Guide 304