ZyXEL ZyWALL ATP700 User Guide - Page 72

Chapter 3 Hardware, Interfaces and Zones Figure 52 ATP200 Rear Panel Figure 53 ATP500 Rear Panel Figure 54 ATP700 / ATP800 Rear Panel Note: Make sure you connect the Zyxel Device's power cord to a socket-outlet with an earthing connection or its equivalent. The following table describes the items on the rear panel. Table 13 Rear Panel Items LABEL DESCRIPTION Console You can use the console port to manage the Zyxel Device using CLI commands. You will be prompted to enter your user name and password. See the Command Reference Guide for more information about the CLI. When configuring using the console port, you need a computer equipped with communications software configured to the following parameters: Power Lock Fan • Speed 115200 bps • Data Bits 8 • Parity None • Stop Bit 1 • Flow Control Off Use the included power cord to connect the power socket to a power outlet. Turn the power switch on if your Zyxel Device has a power switch. Attach a lock-and-cable from the Kensington lock (the small, metal-reinforced, oval hole) to a permanent object, such as a pole, to secure the Zyxel Device in place. The fans are for cooling the Zyxel Device. Make sure they are not obstructed to allow maximum ventilation. Note: Use an 8-wire Ethernet cable to run your Gigabit Ethernet connection at 1000 Mbps. Using a 4-wire Ethernet cable limits your connection to 100 Mbps. Note that the connection speed also depends on what the Ethernet device at the other end can support. 3.2 Installation Scenarios The Zyxel Device can be: ZyWALL ATP Series User's Guide 72