Alpine IVA D106 Owner's Manual - Page 12

Getting Started Accessory List • Head unit 1 • Power Cable 1 • Pre OUT/AUX cable 1 • iPod Video FULL SPEED™ Connection Cable 1 • Mounting Sleeve 1 • Mounting Bracket 2 • Flush Head screw (M4 x 3 8 • Hexagon washer-head screw (M4 x 6 4 • Front Frame 1 • Remote Control 1 • Battery (CR2025 1 • Carrying bag 1 • Owner's Manual 1 set BAND/SAT button Radio mode: Changes the band. Visual source (except navigation screen): Changes the display mode. Press this button for at least 2 seconds to recall a weather channel or traffic channel. Note however, this setting can be made only if the XM or SIRIUS Receiver Box is connected. Remote Sensor Point the supplied remote control transmitter towards the remote sensor within a range of 2 meters. VISUAL button Press and hold for at least 2 seconds to recall the VISUAL selection screen. If VISUAL is set in "Setting the VISUAL Button" (page 39), momentarily press to recall the VISUAL selection screen, and if NAV. is set, momentarily press to recall the navigation screen. OPEN/CLOSE/FLAT button Opens the monitor. Closes the monitor by pressing and holding for at least 2 seconds. Press to set the open monitor to the flat position. button Ejects a disc. button Use this button to remove the front panel. DISC IN Indicator Lights up when a disc is inserted in the unit. Power Indicator This indicator is lit when power is on. • The buttons on the face of this unit are shown in bold (e.g. SOURCE/ ). The onscreen buttons that appear in the display are shown in bold enclosed by [ ] (e.g. [BAND]). Connectable to Remote Control Interface Box You can operate this unit from the vehicle's control unit when an Alpine Remote Control Interface Box (optional) is connected. For details, contact your Alpine dealer. Location of Controls Rotary encoder/MUTE/AUDIO Adjust the volume by turning to the left or right. Press the Mute mode on or off by pressing repeatedly. If pressed and held for at least 2 seconds, the audio setup screen is displayed. SOURCE/ button Turns the power on. Press and hold for at least 2 seconds to turn the power off. Monitor open: Recalls the SOURCE selection screen. Monitor closed: Changes the source. 10-EN